Heat Pump Information

Sump pump installation can seem like a hard and dirty job. But knowing how to create a good sump pit makes a difference in the overall operation of the sump pump over time. The first consideration any homeowner should make is where does the pump need to be installed? Is the pump for use in a basement, crawl space, cellar, or perhaps a roof. Installation will vary depending on the type of pump and the use it’s intended for. For the sake of pit installation any references will be for a submersible pump.

Determine if your bath has positive or negative pressure. If the cold water tank is above your tank level, it is positive. If it is lower, you have negative water pressure. Check the pump specs so you don’t make a mistake when you shop.

Your discharge line can also be a problem. Make sure that your sump borehole yield test isn’t pushing more water into the discharge pipe than it can hold and that your discharge pipe doesn’t freeze in the winter, causing the sump pump to back up. As a final precaution, you’ll need to be sure that you’re not discharging the water straight into the next yard, or you’ll have them to deal with angry neighbors as well!

Installing a sump pump is back-breaking work! It will take a single person many days to install a sump pump and perimeter drain. And if you don’t have access to a jackhammer, it’ll be even more work! You’ll have cement and dirt to remove from the basement, dust to deal with, and an exhausting and sometimes frustrating job on your hands. And if you don’t have a jackhammer, how do you plan to break through the floor?

Put the pump onto a four-inch part of concrete that is not linked to your house. Make positive that the area of concrete is stage and surrounded with gravel so you do not have any troubles draining dampness out of the pump. Allow a clearance place of three inches at the warmth pump’s coil, located at the base of the system, as this will make powerful drainage to stop a buildup of frost.

The type of soil surrounding a home needs to be taken into account. Some areas of the country like the Western Hemisphere have a lot of clay in the soil. This can cause the ground to expand and may cause foundational issues. The area the pit is put in needs to be where the best soil with a sandy consistency. This will allow water to drain much easier. Be sure to place the pit in a location that will be very accessible for future repairs and replacement.

Most pits should optimally be 1 1/2 feet in circumference and 2 feet deep. Be sure to place all downspouts in the opposite direction of the foundation to protect it. Be certain to place all drainage from the pit in such a way that it will not drain into the sewer or a septic system. It is against the law to allow pumping from the pit into any sewer system. This can cause a sewer backup.

Recent Posts

Categories

Categories

Contact Us

Appraisers
688 Philli Lane, Tulsa, OK , 74136

Call Us: 918-496-6993
http://zaccasacca.com

Address
FREE CONSULTATION
Consultation Banner

GET A FREE ESTIMATE

Contact Form